Adjust shift lever if required. The 40 amp fuse will be installed later in the fuse holder located just forward of the expansion tank. The steel pallets have fork openings Figure 1-2. Headlamps: Inspect and adjust as necessary. This motorcycle is equipped with the Harley-Davidson Fac- Handlebar surface contains range marks to properly tory Security System and siren.
Come and say hi on. Engine idle speed may increase during engine break-in. Rear Master Cylinder Shown Use only D. Installing Maxi-Fuse Throttle cam stop Cable housing Spring Throttle cam Idle speed adjusting screw Figure 5-3. Test handlebar switches to make sure they are function- ing properly and wiring has not become pinched or oth- erwise damaged. See Softail Models Service Manual. Tighten screws to 30-50 in-lbs 3.
Screw coaxial cable connector 1 into coaxial adapter on antenna chassis mount. Batteries contain sulfuric acid, which could cause severe This motorcycle is equipped with the Harley-Davidson Fac- burns to eyes and skin. Remove eight fasteners 11 securing headlamp assem- bly 10. Once again - Thank you for shopping at cbssm. Rear Brake Master Cylinder Models Service Manual.
If the open circuit disconnected voltage reading is still below 12. Right turn signal Figure 7-2. Screw antenna 3 onto chassis mount and tighten set screw with allen wrench 4. Tighten mirror fasteners to 12 ft-lbs 16. You are just one click away from the backup service manual you are searching for! Mirror Star washer Acorn nut Front directional lamp Figure 3-7.
Install brake line in clamp 5 in underside of lower fork clamp. Tighten screw 6 to 96-120 in-lbs 10. Use idle speed listed in the Dyna Models Service Manual at Initial Maintenance check. Harley Davidson Service Manuals are available for immediate download. Idle speed adjusting screw Figure 4-2.
. Turn adjusters in direction which will shorten cable hous- ings to minimum length. Coaxial adapter Antenna chassis mount Antenna Allen wrench Figure 7-28. Headlamps: Inspect and adjust as necessary. Failure to do so can cause damage to motorcycle.
Mirrors: Inspect and adjust as necessary. Tighten rear handlebar clamp screws to 16. Squeeze two external tabs if present to remove wire connector at back of headlamp bulb. Shift transmission to neutral position, and verify that neutral indicator lamp turns on again. Interchanging front and rear tires can cause tire failure, which could result in death or serious injury. Rear screw 2 Front screw 2 Upper clamp Figure 1-17.
If we can provide additional assistance of any kind please feel free to and tell us what you need. Additional paint repair information is available 1. Use idle speed listed in the Sportster Models Service Manual at Initial Maintenance check. Also, if eyebolt is not removed, the left radiator trim or other low-left-side com- ponents could be damaged when motorcycle is rolled off pallet. Removing Footrest Rubber Insert 10773 Figure 7-9. After downloading your Harley Davidson backup service manual you can view it on your computer or print one or all of the pages needed. Softail models: tighten rear screws to 12-15 ft-lbs 16.