Remove the three M2 x 3-mm screws from the smartcard assembly. Press the card down and hold it in place. See photo below for correct slider latches positions. Follow the procedures in After Working on Your Computer. Loosen the one captive screw highlighted.
Shown in image below 5. Allows you to view and clear the Thermal events. Remove the express card cage see Removing the Express Card Cage. Replace the bottom access panel see Replacing the Bottom Access Panel. Lift the palm rest from the computer. Replace the two M3 x 3-mm screws. Replace and tighten the two M2 x 3-mm screws.
Position the two lower corner dampners smooth surface on back side into the Display Back. Replace and tighten the three M2x3 mm screws. Remove the display bezel see Removing the Display Bezel. Slide the hard drive into the hard drive module carrier and secure from bottom using four M3 x 4 mm screws. Align the gasket on the fan cable to the cutout in the base chassis and slide into place.
Default Setting: Enable Adapter Warnings is selected. Align the display hinges with the holes in the base of the computer, and lower the display into place. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Follow the procedures in After Working on Your Computer. Default Setting: Disabled Allows you to enable or disable the ExpressCharge feature. Lift up to remove the smartcard housing from the base assembly. Allows you to enable or disable the wireless devices.
Follow the procedures in After Working on Your Computer. The card pops up at a 45-degree angle. Remove the bottom access panel see Removing the Bottom Access PaneH. Continue until the smartcard assembly is free from the base assembly. Remove the palm rest see Removing the Palm rest.
Replace the system board see Replacing the System Board Assembly. If the card has three triangles on the label white, black, and gray , connect the white antenna cable to the white triangle, connect the black antenna cable to the black triangle, and connect the gray antenna cable to the gray triangle. No error message indicates this failure. Follow the procedures in After Working on Your Computer. Connect any external devices, such as a port replicator, battery slice, or media base, and replace any cards, such as an ExpressCard. Depending on your computer and installed devices, the items listed in this section may or may not appear.
Default Setting: Enable Numlock is selected. There is a gasket attached to the perimeter of the bottom access panel, and this gasket might provide some resistance during removal. This code persists if no processor is detected. Allows you to set the time at which the computer must turn on automatically. Remove the display bezel see Removing the Display Bezel. Replace the display cable channel covers see Replacing the Display Cable Channel Covers. Follow the procedures in After Working on Your Computer.
Replace and tighten the M2 x 3-mm screw highlighted in the figure above. Remove the M2 x 3-mm screw. Remove the display assembly see Removing the Display Assembly. Follow the procedures in Before Working on Your Computer. Insert keyboard starting with the top edge. Test the other slot with both modules. Disconnect any cables from the card.