Road Clearance 125 mm 4. Rear Wheel Rotation Sensor 4. Torque - Fuel Level Sensor Bolts: 6. And get the usable range of the atmospheric pressure sensor output voltage and check if output voltage is within the standard or not in the same way as Output Voltage Inspection of. An imbalance of less than 10 grams 0. To the fitting of the throttle body 4. If there is the continuity in the lead, replace the fuse.
We accept payments on behalf of our merchants and send payouts once per week. If the fluid level is lower than the lower level line, fill the reservoir to the upper level line in the reservoir. If the connector is corroded or dirty, clean it carefully. If the surface is corroded or if the blades are damaged, replace the water pump assy. Wheel Balance 10 g 0. If the steering is too loose, tighten the stem nut a fraction of a turn.
Drive Chain Wear 20-link 323 mm 12. Water Temperature Sensor Circuit 1. Subthrottle valve actuator trouble Inspect see chapter 3. The fuel pump should operate for 3 seconds, and then should stop. Ignition Fuse 10 A 17. If the spring of either fork leg is shorter than the service limit, it must be replaced.
Torque - Fuel Level Sensor Bolts: 6. This will burn out the diodes on the electrical parts. It is this level of detail, along with hundreds of photos and illustrations, that guide the reader through each service and repair procedure. Make sure the area is well-ventilated and free from any source of flame or sparks;. Be sure to maintain proper alignment and use smooth movements when installing.
A tester other than the Kawasaki Hand Tester may show different readings. Take out only the caliper mounting bolts for caliper removal. Do not use fluid from a container that has been left unsealed or that has been open for a long time. Brake Pipe One White Paint Mark 6. If it does not, adjust the brake light switch.
Ignition Fuse 10 A 6. Such a shock to the sensor can damage it. These manuals are your number one source for repair and service information. If the camshaft journal diameter is less than the service limit, replace the camshaft with a new one and measure the clearance again. If the canister does become contaminated, replace it with a new one. If the bearing is removed, it will need to be replaced with a new one. Repair methods may vary slightly from make to make.
Al- though no adjustments are required, a thorough visual in- spection must be made at the intervals specified by the Pe- riodic Maintenance Chart. Clamp Clamp the right turn signal light lead, and insert the clamp into the middle air inlet duct. Battery Terminal Voltage Standard: 12. L: Apply a non-permanent locking agent. Immobilizer Amplifier Failure When Registered User Key is Inserted. Wheelbase 1 460 mm 57.
Take care not to damage the crankcase. Connecting Rod Big End Side 0. Install the shim specified where the lines intersect. Align the brake pipes with groove of the frame. Red Hose Right, Return 8. The headlight comes on after the starter button is released and stays on until the ignition switch is turned off. You name it and its in here.